The D.Module.C6713 is a universal floating-point DSP system, based on the Texas Instruments TMS320C6713 processor.

This is a legacy product, which is still in full production, however, not recommended for new designs. Please consider the D.Module2.C6747.

DSP TMS320C6713 300 MHz floating-point DSP, 200 MHz in industrial grade
Memory DSP-internal 4K bytes data cache, 4K bytes program cache, 64K bytes level-2 cache, 192K bytes direct mapped memory
  SDRAM 128M bytes, 100 MHz operation, 32-bit wide
  Flash 2M bytes NOR
UART 1 transmit and receive Fifo, DMA support, RS232: max 230,4K baud, automatic flow-control, optional RS422/485: max. 500K baud
McBSP 2 independent receivers and transmitters, max. 50 Mbps throughput
Timer 2 32-bit
I2C 1 master and slave mode
Host Port Interface 1 16-bit
GPIO 16/42 bit-wise programmable, input or output, 42 if HPI interface is not used, XC9572XL user-programmable CPLD
External Bus Interface EMIF asynchronous transfers, 32-bit data bus, 20 address lines, 2 pre-decoded chip selects, configurable timing
System Supervisor   voltage and watchdog
Emulation Interface   JTAG
I/O Level LVTTL / LVCMOS 5V TTL/CMOS tolerant
Power Supply 3.3V single supply, 500mA typ.
Firmware D.Module.BIOS bootloader, board initialization, board configuration, flash memory programming, UART I/O
  Setup Utility program and data file uploads to the flash memory via UART
Temperature Range   0 – 70°C or -40 – 85 °C
Connectors   2,54mm pitch through-hole connectors
  JTAG 14-pin, 2.54mm pitch
Mechanics   85 x 59 mm, overall height: 15mm
ROHS   compliant
Ordering Information
D.Module.C6713-300-D4 standard module
D.Module.C6713-200I-D4 industrial grade module, 200 MHz
Options -422 : RS422/485 UART line interface